RV Safe error code Red LED flashing once each second, no sound
Alarm Silenced state: Silence/Test was pressed during a CO or propane alarm. The alarm is muted for up to 5 minutes; the red LED flashes each second; the original alarm state resumes after 5 minutes if CO or propane levels still exceed safe levels.
What to check, and in what order, is in the app. The flow RV Safe RVCOLP / RVLP - alarm, LED and self-test signal decoder walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- RV Safe CO & Propane Gas Alarm RVCOLP-2 / Propane Gas Alarm RVLP-2 Owner's Manual, REV 06.01.22 (90-5012-20)RV Safe LLC
- RV Safe CO & Propane Gas Alarm RVCOLP-2 / RVCOLP-3 and Propane Gas Alarm RVLP-2 / RVLP-3 Owner's Manual, REV 12.05.19 (90-4074-00)RV Safe LLC
Related codes
- Green LED flashing, red off, no sound (first 3 minutes after power-up)Warm-Up state (REV 06.01.22 manual only): the green LED flashes for…
- Red LED on/flashing + 4 chirps then constant beeps, right after pressing Silence/TestSelf Test PASSED: pressing Silence/Test in normal operation tests the…
- Red LED flashing + 4 rapid chirps, 4 s pause, repeatingCO ALARM (RVCOLP models only): CO exceeded the detection threshold…
- Red LED on + constant beepsPROPANE ALARM: propane at the sensor exceeded the alarm threshold for…
- Both LEDs flash once each minute + 1 chirp each minuteLOW BATTERY state: the 12 VDC supply has dropped below the…
- Both LEDs flash once each minute + DOUBLE chirp each minuteHIGH VOLTAGE state (REV 06.01.22 manual only - the REV 12.05.19…
- Red LED double-flash each minute + 1 chirp each minuteEND-OF-LIFE or OTHER FAILURE state: the CO or propane alarm failed a…
- Long beep + red LED blinking, right after pressing Silence/TestSELF TEST FAILURE - CO or propane sensor failure, or End-of-Life.…