RV Safe error code Green LED flashing, red off, no sound (first 3 minutes after power-up)
Warm-Up state (REV 06.01.22 manual only): the green LED flashes for the first 3 minutes after power-up and the alarm will not detect CO or propane during those 3 minutes. The REV 12.05.19 manual has no warm-up state in its table; it says only that the alarm will not detect CO or propane for the first 30 seconds and draws extra current for 30 seconds after power-up. Two official revisions are archived and disagree; both values are stated. REV 06.01.22 = rvsafealarm.com copy (RVCOLP-2 / RVLP-2); REV 12.05.19 = Forest River copy (adds the 3-wire RVCOLP-3 / RVLP-3).
What to check, and in what order, is in the app. The flow RV Safe RVCOLP / RVLP - alarm, LED and self-test signal decoder walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- RV Safe CO & Propane Gas Alarm RVCOLP-2 / Propane Gas Alarm RVLP-2 Owner's Manual, REV 06.01.22 (90-5012-20)RV Safe LLC
- RV Safe CO & Propane Gas Alarm RVCOLP-2 / RVCOLP-3 and Propane Gas Alarm RVLP-2 / RVLP-3 Owner's Manual, REV 12.05.19 (90-4074-00)RV Safe LLC
Related codes
- Green LED on, red LED off, no soundNormal operation: the alarm is functioning normally and no CO or…
- No LEDs lit, no soundPower Off state: the alarm has no 12 VDC supply. Both manuals: if no…
- Red LED on/flashing + 4 chirps then constant beeps, right after pressing Silence/TestSelf Test PASSED: pressing Silence/Test in normal operation tests the…
- Red LED flashing + 4 rapid chirps, 4 s pause, repeatingCO ALARM (RVCOLP models only): CO exceeded the detection threshold…
- Red LED on + constant beepsPROPANE ALARM: propane at the sensor exceeded the alarm threshold for…
- Red LED flashing once each second, no soundAlarm Silenced state: Silence/Test was pressed during a CO or propane…