Error codes › Leveling & Stabilization Systems › EQ Systems Auto-Level / Smart-Level › JACKS DOWN LEDs stay on after ALL RETRACT
EQ Systems Auto-Level / Smart-Level error code JACKS DOWN LEDs stay on after ALL RETRACT
The jacks-down light next to each pair of arrows says the jack(s) are not fully stowed. If it will not go out after ALL RETRACT - or goes out and the pump stops before the jacks are up - the fault is in the pressure-switch circuit: the switch, the panel/controller, or the yellow/black wire shorted to ground. Auto-level is denied while jacks-down lights are on.
What to check, and in what order, is in the app. The flow EQ Systems Smart-Level / Auto-Level - panel, pump, jacks and status lights (control circuit) walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Basic Trouble Shooting - Smart-Level Control Circuit (R1)EQ Systems (formerly Equalizer Systems)
- Basic Trouble Shooting for Auto-Level - For Systems Using Current Controller/Keypad (Forest River library title: 'Auto Level Model Smart-Level Basic Troubleshooting')EQ Systems (formerly Equalizer Systems)
Related codes
- LOW VOLTAGE LEDVoltage to the panel (Smart-Level) or controller (New-Platform) has…
- ENGAGE PARK BRAKE LEDThe park-brake input (black wire with yellow trace) is not grounded…
- IGNITION ON LEDThe ignition key is in ON (engine run) with the panel powered (pink…
- EXCESS SLOPE LEDShown after an unsuccessful auto-level: the system could not level…
- JACKS DOWN LEDs come on during travelLoss of fluid pressure in the retract side of the hydraulic circuit…
- Deny tone when extendingThe panel refuses jack extension (manual DOWN or AUTO LEVEL) because…
- POWER LED flashingSleep mode after five minutes of inactivity - not a fault. The flash…
All Leveling & Stabilization Systems error codes · Look up another code