Error codes › Leveling & Stabilization Systems › EQ Systems Auto-Level / Smart-Level › EXCESS SLOPE LED
EQ Systems Auto-Level / Smart-Level error code EXCESS SLOPE LED
Shown after an unsuccessful auto-level: the system could not level within 0.5 degree front-to-rear and side-to-side (EQ020R5: about 7/16 in over 4 ft), or a jack ran out of travel first. Other lights usually show the underlying fault. If it is NOT lit after auto-level, the system finished within specification.
What to check, and in what order, is in the app. The flow EQ Systems Smart-Level / Auto-Level - panel, pump, jacks and status lights (control circuit) walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Basic Trouble Shooting - Smart-Level Control Circuit (R1)EQ Systems (formerly Equalizer Systems)
- EQ Smart-Level Installation/Operation/Warranty Guide for Sprinter/Mercedes Chassis (EQ020R5, Dec 2019)EQ Systems (formerly Equalizer Systems)
Related codes
- LOW VOLTAGE LEDVoltage to the panel (Smart-Level) or controller (New-Platform) has…
- ENGAGE PARK BRAKE LEDThe park-brake input (black wire with yellow trace) is not grounded…
- IGNITION ON LEDThe ignition key is in ON (engine run) with the panel powered (pink…
- JACKS DOWN LEDs stay on after ALL RETRACTThe jacks-down light next to each pair of arrows says the jack(s) are…
- JACKS DOWN LEDs come on during travelLoss of fluid pressure in the retract side of the hydraulic circuit…
- Deny tone when extendingThe panel refuses jack extension (manual DOWN or AUTO LEVEL) because…
- POWER LED flashingSleep mode after five minutes of inactivity - not a fault. The flash…
All Leveling & Stabilization Systems error codes · Look up another code