Girard error code MOTOR NOT MOVING
GC1146C is receiving commands but the 12V DC awning motor does not actuate. On the GC1146C the BROWN module wire connects to the WHITE motor wire and the BLUE module wire connects to the BLACK motor wire; the motor needs a solid 12V DC supply (up to ~10A).
What to check, and in what order, is in the app. The flow Girard GC1146C - Motor Not Moving walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- ccd-0008390.txt
Related codes
- No Power / No Beep on Power-UpGC1146C 12V DC motor control module is not powered. On power-up the…
- No Response to Wall Switch (IN/OUT/STOP)GC1146C is powered (beeps once on power-up) but the awning does not…
- Beeping / Pairing Window ActiveThe GC1146C signals state by BEEPING, not by a blinking green LED. It…
- REMOTE SIGNAL NOT RECEIVEDGC1146C is not responding to its G-Link remote handset or wall…
- MOTOR RUNS CONTINUOUSLYThe awning motor does not stop at the end of travel. On the Girard…
- MOTOR DIRECTION INCORRECTThe awning retracts when it should extend (and vice versa). Direction…
- CONTINUOUS MODE NOT FUNCTIONINGThe awning is in Step mode (operates only while a button is held)…
- STEP MODE NOT FUNCTIONINGThe awning runs fully on a single press (Continuous mode) when Step…
All Awnings (Patio, Window, Slide Topper) error codes · Look up another code