Girard error code Beeping / Pairing Window Active
The GC1146C signals state by BEEPING, not by a blinking green LED. It beeps once on power-up and beeps with each P2 (pairing) press; the pairing/programming window is only 10 seconds. The only blinking LEDs in the system are on the pairing accessories - the anemometer red LED and the motion-sensor purple LED during programming - not on the controller. If you hear beeps during what should be normal operation, a pairing sequence was likely started.
What to check, and in what order, is in the app. A step-by-step flow walks this code with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- ccd-0006100.txt
Related codes
- No Power / No Beep on Power-UpGC1146C 12V DC motor control module is not powered. On power-up the…
- No Response to Wall Switch (IN/OUT/STOP)GC1146C is powered (beeps once on power-up) but the awning does not…
- REMOTE SIGNAL NOT RECEIVEDGC1146C is not responding to its G-Link remote handset or wall…
- MOTOR NOT MOVINGGC1146C is receiving commands but the 12V DC awning motor does not…
- MOTOR RUNS CONTINUOUSLYThe awning motor does not stop at the end of travel. On the Girard…
- MOTOR DIRECTION INCORRECTThe awning retracts when it should extend (and vice versa). Direction…
All Awnings (Patio, Window, Slide Topper) error codes · Look up another code