Lippert Auto Level Pro error code Position of Jack Lost
Controller no longer knows the jack's position — typically after manual override or service.
What to check, and in what order, is in the app. The flow Auto Level Pro — "Open Circuit Detected on Jack" fault walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- ccd-0008574.txt
Related codes
- Open Circuit Detected on JackController cannot energize a jack — open in the actuator or…
- High Current Detected on JackJack hit a high-current condition (overload, jam, or stuck) —…
- Jack Out of StrokeJack cannot extend further — it has reached the end of its travel.
- Position Sensor Signal Lost from JackHall-effect position sensor signal lost mid-operation.
- Controller Power FailurePower input to the leveler controller is no longer working correctly.
- Auto Level TimeoutAuto-level routine could not finish within the allowed time.
- Auto Retract TimeoutJacks did not retract fully within the required time.
- Auto Hitch TimeoutRV could not reach hitch height within the required time.
All Leveling & Stabilization Systems error codes · Look up another code