Lippert Auto Level Pro error code Controller Power Failure
Power input to the leveler controller is no longer working correctly.
What to check, and in what order, is in the app. The flow Auto Level Pro — "Open Circuit Detected on Jack" fault walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- ccd-0008574.txt
Related codes
- High Current Detected on JackJack hit a high-current condition (overload, jam, or stuck) —…
- Jack Out of StrokeJack cannot extend further — it has reached the end of its travel.
- Position Sensor Signal Lost from JackHall-effect position sensor signal lost mid-operation.
- Position of Jack LostController no longer knows the jack's position — typically after…
- Auto Level TimeoutAuto-level routine could not finish within the allowed time.
- Auto Retract TimeoutJacks did not retract fully within the required time.
- Auto Hitch TimeoutRV could not reach hitch height within the required time.
- Ground Jacks TimeoutGround-jacks operation could not finish in time.
All Leveling & Stabilization Systems error codes · Look up another code