Lippert Auto Level Pro error code Auto Level Timeout
Auto-level routine could not finish within the allowed time.
What to check, and in what order, is in the app. The flow Auto Level Pro — "Open Circuit Detected on Jack" fault walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- ccd-0008574.txt
Related codes
- Jack Out of StrokeJack cannot extend further — it has reached the end of its travel.
- Position Sensor Signal Lost from JackHall-effect position sensor signal lost mid-operation.
- Position of Jack LostController no longer knows the jack's position — typically after…
- Controller Power FailurePower input to the leveler controller is no longer working correctly.
- Auto Retract TimeoutJacks did not retract fully within the required time.
- Auto Hitch TimeoutRV could not reach hitch height within the required time.
- Ground Jacks TimeoutGround-jacks operation could not finish in time.
- Excess Angle DetectedRV exceeded the maximum allowed body angle during auto operation.
All Leveling & Stabilization Systems error codes · Look up another code