Error codes › Diesel Air Heaters › Eberspacher EasyStart Pro control unit (controller display - not a heater code) › Heater ON for 10 Min.
Eberspacher EasyStart Pro control unit (controller display - not a heater code) error code Heater ON for 10 Min.
Maintenance prompt, not a fault: after four months without operation the controller asks for HEATING to be run for 10 minutes, even in summer, to clear residues from the combustion chamber.
What to check, and in what order, is in the app. The flow Eberspacher EasyStart Pro - what the controller is showing (control-unit codes 1-9 + heater messages) walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Eberspacher EasyStart Pro Operating Instructions 22.1000.35.2204.0A (EN, 07.2021)Eberspacher Climate Control Systems GmbH
Related codes
- Water Circuit or PumpWATER heaters only (Hydronic S3): water temperature in the heater too…
- Air Ducting or OutletAIR heaters only: air outlet temperature in the heater too high…
- Overheat. Heater locked.Overheating detected and the heater is interlocked (locked out) for…
- Restricted OperationEmergency running: a heater fault exists but restricted operation…
- 1Ext. Temp. Sensor defective - the external temperature sensor…
- 2Int. Temp. Sensor defective - the temperature sensor inside the…
- 3Rotary Knob jammed - the operating button (rotary knob) is blocked…
- 4Pushbutton jammed - the BACK button is blocked (control-unit message).