Error codes › Diesel Air Heaters › Eberspacher EasyStart Pro control unit (controller display - not a heater code) › Water Circuit or Pump
Eberspacher EasyStart Pro control unit (controller display - not a heater code) error code Water Circuit or Pump
WATER heaters only (Hydronic S3): water temperature in the heater too high (heater message).
What to check, and in what order, is in the app. The flow Eberspacher EasyStart Pro - what the controller is showing (control-unit codes 1-9 + heater messages) walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Eberspacher EasyStart Pro Operating Instructions 22.1000.35.2204.0A (EN, 07.2021)Eberspacher Climate Control Systems GmbH
Related codes
- ServiceHeater fault that only a specialist workshop can remedy (heater…
- UndervoltageUndervoltage at the heater control box without interruption for at…
- OvervoltageOvervoltage at the heater control box without interruption for at…
- Fuel Supply or PumpFault in the fuel supply or the metering pump (heater message).…
- Air Ducting or OutletAIR heaters only: air outlet temperature in the heater too high…
- Overheat. Heater locked.Overheating detected and the heater is interlocked (locked out) for…
- Restricted OperationEmergency running: a heater fault exists but restricted operation…
- Heater ON for 10 Min.Maintenance prompt, not a fault: after four months without operation…