Go Power error code 31
Reported by the controller as the named status 'Charge Temperature Limits Violation' (not a numbered fault code): 'The battery temperature is outside of the acceptable range of operating temperatures at the current charging rate.'
What to check, and in what order, is in the app. The flow Go Power Solar Controller — Entry Diagnostic walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Go Power GP-SB-PWM-10-30BT ManualGo Power
Related codes
- Battery Disconnected (<3.0 V)Battery disconnected or below 3.0 V at the battery input (LCD…
- Battery Reverse ConnectionBattery reverse polarity (red/black swapped at the controller's…
- Battery Over-Voltage (>17.5 V)Battery-input voltage above 17.5 V (LCD 'Battery over voltage than >…
- 32Controller cannot detect a battery — 5-pulse wake-up sequence failed…
- E1Battery over-discharge -- output/charging cut to protect an…
- E2System over-voltage -- battery-bank voltage above the safe upper limit
- E3Battery under-voltage warning -- battery voltage below the…
- E4Load short circuit on the controller's LOAD output