Go Power error code E1
Battery over-discharge -- output/charging cut to protect an over-discharged battery
What to check, and in what order, is in the app. The flow Go Power Solar Controller — Entry Diagnostic walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Go Power GP-MPPT-PRO-40 Manual (82803)Go Power
Related codes
- Battery Reverse ConnectionBattery reverse polarity (red/black swapped at the controller's…
- Battery Over-Voltage (>17.5 V)Battery-input voltage above 17.5 V (LCD 'Battery over voltage than >…
- 32Controller cannot detect a battery — 5-pulse wake-up sequence failed…
- 31Reported by the controller as the named status 'Charge Temperature…
- E2System over-voltage -- battery-bank voltage above the safe upper limit
- E3Battery under-voltage warning -- battery voltage below the…
- E4Load short circuit on the controller's LOAD output
- E5Load overloaded -- LOAD-terminal draw exceeds the controller's rating