Norcold N15DCX/N20DCX (1520cu) error code 5 flashes (compressor self-test)
Thermal Cut-Out of Compressor Power Module. The compressor power module circuit board temperature is above 203°F (95°C). (Source manual: Test E.) The refrigerator will not restart until the module cools below 165°F (74°C).
What to check, and in what order, is in the app. The flow Norcold 1520cu (N15DCX / N20DCX) — Compressor Refrigerator Diagnostic walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Norcold N15DCX/N20DCX Service Manual 641052C Rev (Thetford) [on disk, fetched 2026-06-08]
- Norcold DCX Service Docs
- Norcold N15DCX/N20DCX 1520cu Service Docs
- Secop BD35F/BD50F Service Manual
Related codes
- 1 flash (compressor self-test)Compressor Power Module Battery Protection Cut-Out. The DC voltage at…
- 2 flashes (compressor self-test)Fan Over Current Cut-Out. The compressor power module sensed more…
- 3 flashes (compressor self-test)Compressor Motor Start Error. The rotor is blocked or the…
- 4 flashes (compressor self-test)Minimum Compressor Motor Speed Error. The motor cannot maintain the…
- 6 flashes (compressor self-test)Compressor Power Module Hardware Failure. (Source manual: Test K…
- E1Fresh food compartment thermistor not cycling properly. The…
- E2Freezer compartment thermistor not cycling properly. Same logic as E1…
- E3Voltage outside the cut-out setting. The user-interface cut-out range…