Norcold 1210T error code Flashing temp setting (thermistor)
Temperature setting flashes — thermistor disconnected/open OR thermistor wiring corroded/broken.
What to check, and in what order, is in the app. The flow Norcold 1210T — error code / symptom diagnostic walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Norcold 1200/1210 Series Service Manual (Publication 630613B, 08-10-07)Norcold
Related codes
- L1 oPHigh-temperature limit switch open — boiler exceeded 378 °F
- FL --Flame sensed at burner when gas is supposed to be off
- drDoor sensed ajar or open for more than 2 minutes
- Blank displayNo display segments, refrigerator does not turn on
- Alternating display + alarm (extended)Alternating display + alarm pattern from the 1210T power board. Three…
- AC HEAC heaters failed open — recorded in AUTO or Manual AC mode when…
- AC rEAC relay stuck closed — AC heater current is sensed when it is…
- SrFlame sensing malfunction — recorded in all modes when: (1) a problem…