Error codes › Leveling & Stabilization Systems › Lippert Ground Control 3.0 (One-Touch) › BAD CALIBRATION (One-Touch)
Lippert Ground Control 3.0 (One-Touch) error code BAD CALIBRATION (One-Touch)
OneControl Touch Panel shows BAD CALIBRATION - the trailer's zero point was not set correctly.
What to check, and in what order, is in the app. The flow GC 3.0 One-Touch — Zero Point Calibration (OneControl procedure) walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Lippert Ground Control (5th Wheel) 4-Point and 6-Point OneControl Touch Panel Owner's Manual (Rev 11.20.24) - OneControl Touch Panel/App Error Codes (p15) + Special Jack Error Codes (p16)Lippert Components
Related codes
- LED Solid RedAuto Leveling Control Touch Pad LED is solid red — low battery.
- LED Blinking RedAuto Leveling Control Touch Pad LED is blinking red — a fault is…
- OUT OF STROKE (One-Touch)OneControl shows OUT OF STROKE — controller is loose/unsecured OR the…
- AUTO LEVEL FAIL (One-Touch)OneControl AUTO LEVEL FAIL - controller is unsecured OR battery…
- EXCESSIVE ANGLE (One-Touch)OneControl EXCESSIVE ANGLE during MANUAL operation — user has…
- HALL POWER SHORT (One-Touch)Short circuit detected on one or more of the jack hall-effect power…
All Leveling & Stabilization Systems error codes · Look up another code