Camplux RS264 (RV tankless) error code E6
Temperature surge alarm - the outlet temperature swung outside control, usually from a water-side cause: a cold-water surge, too much cold mixing, low supply or flow, air in the lines, a plugged inlet filter, or a faucet flowing less than the 0.32 gpm minimum. The table also lists a temperature sensor or system fault.
What to check, and in what order, is in the app. The flow Camplux RS264 / RS264B - error codes E0-E7 walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Camplux 2.64 GPM RV Tankless Water Heater - Instruction For Installation And Use, Model RS264/RS264B (PDF title 'RV-M-20220708', modified 2023-03-06)Camplux (North Charleston, SC)
Related codes
- E2Detected fake flame signal - the board sees a flame signal when there…
- E3Over-temperature mechanical sensor fault - the mechanical…
- E4Water inlet temperature sensor fault - the board reads a fault on the…
- E5Air pressure fault - the air (wind) pressure switch did not prove…
- E7Solenoid valve fault - a fault in the gas solenoid valve or its…
All Water Heater — Tankless error codes · Look up another code