Camplux RS264 (RV tankless) error code E2
Detected fake flame signal - the board sees a flame signal when there should be none. Camplux attributes it to the main control board (board failure or faulty program).
What to check, and in what order, is in the app. The flow Camplux RS264 / RS264B - error codes E0-E7 walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Camplux 2.64 GPM RV Tankless Water Heater - Instruction For Installation And Use, Model RS264/RS264B (PDF title 'RV-M-20220708', modified 2023-03-06)Camplux (North Charleston, SC)
Related codes
- E0Water outlet temperature sensor fault - the board reads a fault on…
- E1Flame sense fault - no flame was proven at start-up: not enough gas…
- E3Over-temperature mechanical sensor fault - the mechanical…
- E4Water inlet temperature sensor fault - the board reads a fault on the…
- E5Air pressure fault - the air (wind) pressure switch did not prove…
- E6Temperature surge alarm - the outlet temperature swung outside…
All Water Heater — Tankless error codes · Look up another code