Lippert error code 2
Right motor fault - the GREEN LED blinks once (Basic Fault reporting mode), then the RED LED blinks TWICE. Indicates a problem with the right motor circuit. (SureSlide 2-wire controller; NOT the Schwintek In-Wall scheme.)
What to check, and in what order, is in the app. A step-by-step flow walks this code with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Lippert SureSlider Slide-Out OEM Installation Manual CCD-0009730 (Rev 12.05.25) [on disk]
- Lippert Schwintek In-Wall Service Manual + Tech Bulletins
- Lippert SlimRack + SlimRack Plus Service Manual
- Lippert Through-Frame (hydraulic) Service Manual
Related codes
- 1 Red FlashParking brake (if applicable) is not set OR ground signal is lost at…
- 7 Red FlashesStops have not been set, stops were cleared, or stops were improperly…
- 1Left motor fault - the GREEN LED blinks once (Basic Fault reporting…
- 1F-1GPark Brake Not Set
- 1F-2GLow Voltage (< 10.5V)
- 1F-4GMotor 1 Fault
- 2F-4GMotor 2 Fault