Lippert (Schwintek In-Wall) error code 6
Motor Short Circuit - the motor itself or the wiring to it has shorted out. Note: over-current and short-circuit detection stay enabled even in electronic manual override, so override will not bypass this fault.
What to check, and in what order, is in the app. The flow Schwintek In-Wall — Code 6 (Motor Short Circuit) walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Lippert In-Wall (Schwintek) Slide-Out Troubleshooting and Service Manual (Rev 03.28.23)Lippert Components
Related codes
- 2Battery Drop Out — Battery sagged below ~6V DC during a slide cycle…
- 3Low Battery — Battery voltage was already below 8V DC at the start of…
- 4High Battery — Voltage at the controller is above 18V DC —…
- 5Excessive Motor Current — Motor is drawing too much amperage —…
- 8Missing Hall Effect (encoder) signal — The encoder (Hall effect…
- 9Hall Power Short To Ground - the Hall-effect (encoder) power line has…