MTI Safe-T-Alert 65 Series error code Steady red CO LED + 4 beeps, 5 s silence (repeating)
CO ALARM (65 series CO alarm): the red CO LED flashes and the alarm sounds 4 beeps then is silent for 5 seconds (CO alarm trigger 4-15 minutes at 400 ppm). The cycle continues until TEST/Mute is pressed; the RED light stays on until the CO has cleared, or the alarm reactivates in approximately 6 minutes if CO is still present. The signal table prints the LED as STEADY RED. On -MS interconnected installations every connected unit sounds, but only the alarm that detected CO lights its red LED.
What to check, and in what order, is in the app. The flow MTI Safe-T-Alert 20/25/30/40/45/62/65/85 series - alarm and LED signal decoder walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Safe-T-Alert 65 Series Carbon Monoxide Alarm User's Manual with relay / interconnect wiring (65RV120810-6, 2011)MTI Industries, Inc. (Safe-T-Alert)
Related codes
- Steady green LED, no soundNormal operation (65 series CO detector): powered and monitoring; no…
- Flashing green LED, no sound (warm-up, about 10 min)Warm-up (65 series CO detector): on power-up the CO sensor requires a…
- Alternating red/green LED + 1 beep every 15-30 sMALFUNCTION / SERVICE SIGNAL (65 series CO alarm): the Operational/CO…
- Red-red-green-green flashing LED + beep every 25-30 sEND OF LIFE (65 series CO detector): the CO sensor's 5-year service…
- 1 to 4 chirps + matching green/red blinks after a short Test/Reset press (peak CO memory)PEAK LEVEL MEMORY readout (65 series CO detector): pressing…
- Green operational LED off (dark, no sound)No power / no operation (65 series CO alarm): wire connection…