Error codes › LP / Propane System › MTI Safe-T-Alert 40 Series › Flashing red LED + beep every 30 s (muted alarm)
MTI Safe-T-Alert 40 Series error code Flashing red LED + beep every 30 s (muted alarm)
Alarm in mute cycle (40 series): TEST-MUTE was pressed while gas is still above the alarm level - the red LED continues to flash and the alarm beeps every 30 seconds until the gas level has dropped to a safe level.
What to check, and in what order, is in the app. The flow MTI Safe-T-Alert 20/25/30/40/45/62/65/85 series - alarm and LED signal decoder walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Safe-T-Alert Model 40-441A / 40-442A Propane and Methane Gas Detector User's Manual (Manual #40A96-7, 2006)MTI Industries, Inc. (Safe-T-Alert)
Related codes
- Yellow flashing LED, no sound (warm-up)Warm-up cycle (40-441A / 40-442A): when power is first applied the…
- Solid green LED, no soundNormal operation (40 series): full operation after warm-up; no…
- Flashing red LED + continuous toneALARM (40 series): the red LED flashes and the alarm sounds…
- Flashing green LED, no sound (mute cycle)Mute cycle (40 series): after TEST-MUTE was pressed during an alarm…
- Alternating red/green LED + 2 beeps every 15 sMALFUNCTION ALARM (40 series): the microprocessor detected a fault in…
- LED off (no light, no sound)No power at the detector (40 series): faulty power connections…