Lippert error code ZERO POINT NOT SET
Auto-level cannot run because trailer's level reference point has not been calibrated.
What to check, and in what order, is in the app. The flow Lippert leveling: timeout / 'check components' walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Lippert Ground Control 3.0 Service Manual (Rev 2018-07-31)Lippert
Related codes
- Clutch SlipPower tongue jack slip clutch is slipping (audible clicking).…
- Fuse Blown30A in-line fuse on the jack power lead has blown, cutting power to…
- EXCESS ANGLEUnsecured controller, OR trailer on uneven / sloped ground.
- FEATURE DISABLEDTouch pad power not cycled between consecutive leveling operations…
- LOW VOLTAGEBattery voltage dropped below 10.8 VDC during operation.
- JACK TIME OUTTime limit exceeded for requested auto operation.
- COMM ERRORCommunication lost between controller and touch pad.
- BAD CALIBRATIONSensor calibration values are out of range.
All Leveling & Stabilization Systems error codes · Look up another code