Error codes › Leveling & Stabilization Systems › Lippert Titan Leveling › No Auto Level Position Configured
Lippert Titan Leveling error code No Auto Level Position Configured
The auto-level set point has not been configured; Auto Level cannot run until it is.
What to check, and in what order, is in the app. A step-by-step flow walks this code with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 7 days free, no card neededDocumented in
- Titan Leveling Systems for 5th Wheel - OEM Installation ManualLippert
Related codes
- Controller FailureThe Titan leveling controller reports an internal failure (the manual…
- Configuration FailureThe controller's configuration is faulted. The manual gives no field…
- Low Battery Voltage DetectedBattery voltage is too low for the leveler to operate.
- Short Circuit Detected In Jack Light OutputThe controller detects a short on the jack-light (work light) output…
- Driver's Side Rear Jack Cannot Extend FurtherThe driver's-side rear jack has reached maximum stroke and cannot…
- Passenger's Side Rear Jack Cannot Extend FurtherThe passenger's-side rear jack has reached maximum stroke and cannot…
- Pump Power Breaker TrippedThe inline fuse / breaker between the hydraulic pump and the battery…
All Leveling & Stabilization Systems error codes · Look up another code