Error codes › Laundry (Washer/Dryer)
Laundry (Washer/Dryer) error codes
58 codes from 6 manufacturers, each with its meaning and the document it comes from. Open a code for the details, or search every system.
Furrion Laundry (5)
- E10Water injecting problem while washing — incoming water pressure too low, hose kinked, or inlet valve filter…
- E12Water overflow —
- E21Overtime water draining — drain hose blocked, kinked, or routed with insufficient downhill gradient
- E30Door is not closed properly — door switch not engaging or clothes blocking the door seal
- EXXOther issue / catch-all error code for non-specific faults
Pinnacle 18-4400 (12)
- E1Door close fault - the machine cannot confirm the door is closed/locked. Component: Door Switch.
- E2Drain fault - the machine is not draining. Component: Drain Pump.
- E3Water inlet fault - the machine is not filling. Component: Inlet Valves.
- E4Water overfill fault. Component: Pressure Switch.
- E5Motor fault. Component: Thermal Protector + Electronic Module.
- E6Communication fault between the display and the electronic module. Component: Communication Cable.
- E7Dryer malfunction. Component: Temp. sensor (at the rear-bottom of the tub).
- E8Dryer malfunction. Component: Temp. sensor (at the front of the heater housing).
- E9Water overfill fault. Component: Water level sensor.
- E10Dryer malfunction. Component: Temp. sensor (near the blower fan motor).
- E11Dryer malfunction. Component: Fan Motor.
- E12Dryer malfunction. Component: Heating Element.
Splendide 2100XC (18)
- F01Motor TRIAC short-circuit (board-side TRIAC failed shorted)
- F02Motor blocked, or tachometer open / shorted
- F03Wash NTC open or shorted
- F04Empty + overflow signals present simultaneously - pressure switch jammed
- F05Empty pressure-switch level not reached - drain pump blocked or pressure switch fault
- F06Selector binary code not found
- F07No absorption of wash heater (heater not drawing current when commanded ON)
- F08NA/NC contact of wash heater relay welded
- F09Setup file error - EEPROM not programmed or damaged (most common after a board swap)
- F10No signal of simultaneous empty and full
- F11Drain pump not supplied - no current at the pump
- F12No communication between Control Panel Board and Main Board
- F13Drying NTC open / shorted, or fan motor blocked
- F14No absorption of drying heater
- F15Contact of drying heater relay welded
- F16Drum lock (top-loading models only) - not applicable to RV front-loading 2100XC / 7100XC
- F17Door lock not supplied or open
- F18Communication error between Micro Processor and DSP (board-internal)
Splendide ARxx (3)
- F07Heater relay stuck on the wash-heater branch - board sees heating element circuit closed when it should be…
- F17Door lock error (Indesit digit-display models ARWXF129W, ARWDF129(NA).1, ARXXF125EU). Board cannot confirm…
- F18Communication error between the micro-processor and the motor-control / DSP section of the board.
Splendide Combomatic (14)
- F01Short-circuited Motor TRIAC on Module Board
- F02Blocked Motor or Tachometer Open/Short-Circuited
- F03Wash NTC Sensor Open or Short-Circuit
- F04Both Empty and Over Flow signals present simultaneously (impossible state)
- F05Blocked Drain Pump or Pressure Switch stuck on Empty
- F06Selector Binary Code Not Found (selector position not recognized)
- F08Missing or Incorrect ON/OFF Switch Signal
- F09File Set-Up Error (unverifiable internal fault)
- F10Missing or Conflicting Pressure Switch Signal
- F11Drain Pump Power Supply Failure
- F12Communication Failure
- F13Dry NTC Sensor Open or Shorted Circuit
- F14Dryer Element on, Pressure Switch sensing water in drum
- F15Dry Heating Element Relay Malfunction
Splendide WDV2200XCD (6)
- F1E1General fault (Whirlpool-platform third-generation Splendide combo)
- F4E1Error code shown on the display - not individually defined in the WDV2200XCD IOM, which gives one generic…
- F0E7Clothes detected inside drum during Clean Washer cycle
- F5E4Door must be opened between every 3 consecutive cycles
- F8E1Water-level / fill issue
- F9E1Washer-dryer does not drain (water remains in the drum)