Xantrex Freedom eGEN error code Gateway Cloud LED flashing red
Xantrex Gateway 808-1888: Cloud LED flashing red = a USB stick is connected and the Gateway is either upgrading its software from the USB (around 3-5 minutes) or saving technical-support data logs to the USB (around 3-20 seconds). Not a fault - do not remove the stick until the LED near the USB port turns off.
What to check, and in what order, is in the app. A step-by-step flow walks this code with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Xantrex Gateway Owner's Guide 975-1176-01-01 Rev D (PN 808-1888)Xantrex LLC
Related codes
- B:# / C:# / P:# / #:#SOC Gauge catch-all codes: B:# unknown BMS fault (3 fast, more than 7…
- Orange light on remote panel (low battery)e-GEN remote panel orange light: battery voltage is low, about 12%…
- BMS power-button LED (e-GEN): off / on / rapid flashe-GEN Xantrex BMS LED in the POWER/RESET button: off = BMS off and…
- eGEN Hub LEDs: CONNECTED 1-4 / ALT ENABLE / SHORE POWER / ENGINE ON / CONFIG OUTPUT 1-4Freedom eGEN Hub 820-0080-12 status LEDs: CONNECTED 1-4 light when…
- Gateway Power LED offXantrex Gateway 808-1888 Power LED off = the Gateway is disconnected…
- Gateway CAN LED off / Modbus LED offXantrex Gateway 808-1888: CAN LED off = no CAN (RV-C) device…