Error codes › Inverters › Xantrex Freedom eGEN › BMS power-button LED (e-GEN): off / on / rapid flash
Xantrex Freedom eGEN error code BMS power-button LED (e-GEN): off / on / rapid flash
e-GEN Xantrex BMS LED in the POWER/RESET button: off = BMS off and battery power disabled; on = BMS on, battery power enabled; rapid flashing = BMS in alarm state and battery power disabled.
What to check, and in what order, is in the app. A step-by-step flow walks this code with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Freedom e-GEN System User Guide 975-0791-01-01 Rev H (Jan 2021)Xantrex LLC
Related codes
- B:Cell CountSOC Gauge B:Cell Count (3 fast / 3 slow): BMS reported cell count…
- B:SerialSOC Gauge B:Serial (3 fast / 6 slow): BMS serial mismatch. One of the…
- B:# / C:# / P:# / #:#SOC Gauge catch-all codes: B:# unknown BMS fault (3 fast, more than 7…
- Orange light on remote panel (low battery)e-GEN remote panel orange light: battery voltage is low, about 12%…
- eGEN Hub LEDs: CONNECTED 1-4 / ALT ENABLE / SHORE POWER / ENGINE ON / CONFIG OUTPUT 1-4Freedom eGEN Hub 820-0080-12 status LEDs: CONNECTED 1-4 light when…
- Gateway Cloud LED flashing redXantrex Gateway 808-1888: Cloud LED flashing red = a USB stick is…
- Gateway Power LED offXantrex Gateway 808-1888 Power LED off = the Gateway is disconnected…
- Gateway CAN LED off / Modbus LED offXantrex Gateway 808-1888: CAN LED off = no CAN (RV-C) device…