Onan HGJAA-HGJAF error code 37 (Invalid Configuration)
Wrong frequency/RPM ratio detected (configuration mismatch).
What to check, and in what order, is in the app. The flow Onan Code 37 — Invalid Set Configuration walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Cummins-Onan Service Manual (document 0983-0501 Issue 26, March 2018, 202 pp) covering HGJAA Spec A-E / HGJAB A-E / HGJAC A-C / HGJAD A-E / HGJAE A-E / HGJAF A-C (rv-tech-resources/25-onan-hgjaa/0983-0501_Onan_HGJAA-HGJAF_Service_Manual_Issue_26.pdf)
- Onan HGJAA Generator Technician Service Diagnostic Reference (rv-tech-resources/25-onan-hgjaa/Onan_HGJAA_Generator_Technician_Service_Diagnostic_Reference.md)
Related codes
- 32 (Low Cranking Speed)Cranking too slow: quadrature frequency ≤3 Hz AND engine RPM ≤100 RPM…
- 33NOT ASSIGNED. If seeing blink pattern that looks like 33, it is…
- 35 (Control Card Failure)Microprocessor EEPROM error during self-test.
- 36 (Engine Stopped Without Fault)Engine stopped without command by controller. Manual logic: RPM less…
- 38 (Field Overload / Overcurrent)Field voltage F1-F2 greater than 150 VDC for 10 continuous seconds.
- 41 (Alternator/Generator Rotor Fault)Post-2003 models only. Field voltage F1-F2 = 0 VDC AND sense voltage…
- 42 (Processor Fault - ROM)Microprocessor ROM error during self-test.
- 43 (Processor Fault - RAM)Microprocessor RAM error during self-test.