Cummins-Onan QG i error code 53 (QG 2800i/2500i)
Oil Temperature Sensor Circuit Fault. Oil temperature sensor circuit is open or shorted. The generator set will shut down. QG 2800i / 2500i LP (HGLAA) code table - NOT the HGJAA (0983-0501) or KY table; the same number carries a different meaning on those families and on the QG i DF family (see the '(QG i DF)' entries). All HGLAA fault codes shut the generator set down; the status indicator light in the control switch flashes the code.
What to check, and in what order, is in the app. A step-by-step flow walks this code with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Operator Manual Generator Set HGLAA Spec A (QG 2800i / 2500i LP), A062Y985 Issue 3Cummins Onan
- Operator Manual Generator Set HGLAA Spec B (QG 2800i / 2500i LP), A075S349 Issue 3Cummins Onan
Related codes
- 43 (QG 2800i/2500i)RAM Fault. Errors detected within inverter/controller at startup. The…
- 45 (QG 2800i/2500i)Crank Position Sense Lost. No crank position signal pulses detected…
- 49 (QG 2800i/2500i)Actuator Over Load. No RPM increase after command to open throttle.…
- 52 (QG 2800i/2500i)Injector/Lift Pump Circuit Fault. Injector or lift pump circuit is…
- 54 (QG 2800i/2500i)MAT Sensor Circuit Fault. Manifold Air Temperature sensor circuit is…
- 56 (QG 2800i/2500i)MAP Sensor Circuit Fault. Manifold Absolute Pressure sensor circuit…
- 67 (QG 2800i/2500i)IGBT Over Current Fault. Alternating current output circuit is…
- 74 (QG 2800i/2500i)Unprogrammed Board. Inverter/controller not programmed. The generator…