Cummins-Onan QG i error code 36 (QG 2800i/2500i)
Mechanical Fault. Generator set shut down without inverter/controller command. The generator set will shut down. QG 2800i / 2500i LP (HGLAA) code table - NOT the HGJAA (0983-0501) or KY table; the same number carries a different meaning on those families and on the QG i DF family (see the '(QG i DF)' entries). All HGLAA fault codes shut the generator set down; the status indicator light in the control switch flashes the code.
What to check, and in what order, is in the app. A step-by-step flow walks this code with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Operator Manual Generator Set HGLAA Spec A (QG 2800i / 2500i LP), A062Y985 Issue 3Cummins Onan
- Operator Manual Generator Set HGLAA Spec B (QG 2800i / 2500i LP), A075S349 Issue 3Cummins Onan
Related codes
- 31 (QG 2800i/2500i)Engine Over Speed. Engine speed is above the protection limit. The…
- 32 (QG 2800i/2500i)Crank Under Speed. RPM does not reach minimum cranking speed. The…
- 34 (QG 2800i/2500i)High Inverter Temperature. Inverter switch temperature is above…
- 35 (QG 2800i/2500i)EE Checksum Fault. Errors detected within inverter/controller at…
- 38 (QG 2800i/2500i)Output Over Load. Load current is above the generator set protection…
- 43 (QG 2800i/2500i)RAM Fault. Errors detected within inverter/controller at startup. The…
- 45 (QG 2800i/2500i)Crank Position Sense Lost. No crank position signal pulses detected…
- 49 (QG 2800i/2500i)Actuator Over Load. No RPM increase after command to open throttle.…