Garnet SeeLeveL II error code Err
Signal corruption between a sender and the display. Caused by bad wiring, a defective sender, or multiple senders programmed to the same tank (most common installer error).
What to check, and in what order, is in the app. The flow SeeLeveL — erratic / inaccurate readings walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Garnet SeeLeveL II 709 Series Installation & User Manual v2.0 [on disk: rv-tech-resources/08-garnet-seelevel/seelevel-709-series-manual-v2.0.pdf]
- Garnet SeeLeveL II Service Manual
- Garnet Customer Service 800-490-3158
- seelevel 709 series manual v2.0 (rv-tech-resources/08-garnet-seelevel/seelevel-709-series-manual-v2.0.pdf)
Related codes
- OPnOpen circuit. A sender is unresponsive, or the blue communication…
- shtShort circuit. The blue communication wire from senders to display is…
- StAStacked-sender programming mismatch. The display is programmed for a…
- ntPNo top sender reporting in a stacked-sender configuration. The…
- nboNo bottom sender reporting in a stacked-sender configuration. The…
- CALCalibration failure. The display's internal memory used to store…