Error codes › Inverters › Renogy 1000W/2000W Inverter/Charger › Over-Temp AC Source (red Over-Temp LED, yellow Charger-in-Boost, green AC Source, beep every 1 sec)
Renogy 1000W/2000W Inverter/Charger error code Over-Temp AC Source (red Over-Temp LED, yellow Charger-in-Boost, green AC Source, beep every 1 sec)
Internal temperature exceeded during CHARGING (shore/generator in)
What to check, and in what order, is in the app. The flow Renogy Inverter/Charger — fault LED diagnostic walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Renogy_1000W_2000W_Pure_Sine_Wave_Inverter_Charger_Manual.pdf
Related codes
- Low Bat Volt (beep every 1 sec)Battery voltage dropped below 10.5 V DC low-voltage alarm threshold
- High Bat Volt (beep every 5 sec)Battery voltage exceeded 16 V DC limit
- Over-Load (red Over-Load LED on, green Inverter LED on, beep every 1 sec)Load exceeds 1000W (1000W model) or 2000W (2000W model)
- Over-Temp (red Over-Temp LED on, green Inverter LED on, beep every 1 sec)Internal temperature exceeded safe limit during inverter operation
- Over Charge (yellow Charger-in-Boost LED on, green AC Source, beep every 1 sec)Charge output exceeded expected value (algorithm issue or sensor…
- Fan Lock (continuous beep, no other LEDs)Cooling fan mechanically stuck or motor failed
- Output Short (red Over-Load LED, continuous beep)Short circuit detected on AC output
- Back Feed Short (continuous beep, no other LEDs)Incorrect AC source connection causing feedback into inverter output