Error codes › Hydronic Heat › Truma Combi 4/6 E (older boards, pre-CP Plus) › 206

Truma Combi 4/6 E (older boards, pre-CP Plus) error code `206`

FaultHydronic HeatVerified against the manufacturer's manual

Combi 4/6 E: dirty supply voltage (AC components in power supply)

What to check, and in what order, is in the app. The flow Truma Combi — 12V Supply Diagnostic walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.

Start free trial 14 days free, no card needed

Documented in

Truma Combi Diagnostics Catalogue (2019-09-10)Truma
_catalogue_extracted.txt

Related codes

202Combi 4/6 E older boards: flame not detected (or poor earth/battery…
203Combi 4/6 E: flame not expected (ionization voltage in standby mode)
208Combi 4/6 E: combustion engine RPM too low
209Combi 4/6 E: combustion engine RPM too high
210Combi 4/6 E: electronic fault on PCB

All Hydronic Heat error codes · Look up another code

Truma Combi 4/6 E (older boards, pre-CP Plus) error code 206

Documented in

Related codes

Truma Combi 4/6 E (older boards, pre-CP Plus) error code `206`