Atwood AFM (LED-blink) error code STEADY ON
Steady-on LED with no flashing pattern indicates an internal failure on the ignition control module. HARD lockout.
What to check, and in what order, is in the app. The flow Atwood: Internal Circuit Board Failure walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Atwood/Dometic Service Manual P/N 33176 (revs A-D+) - myrvworks.com + technicianhq.com
- Atwood AFMD Installation & Service Manual - dometic.com/en-us/support
- Dometic Service (RV) 1-574-294-2511 (Elkhart IN)
- Atwood AFM LED diagnostic patterns (1F limit/airflow, 2F flame sense, 3F ignition, steady = board internal failure) - documented in Atwood Service Manual 33176 §LED Diagnostic Indications
Related codes
- 1 FLASHLimit switch is open or airflow is insufficient. SOFT lockout —…
- 2 FLASHBurner lit but flame sense circuit failed to detect flame. HARD…
- 3 FLASHBurner did not light after 3 ignition attempts. SOFT lockout with…
All Furnace (Forced-Air LP) error codes · Look up another code