Schneider Conext error code W94
Remote Power Off: the unit was turned off with a Remote Power Off switch. It stops inverting/charging and shuts down after five seconds; a master signals other network devices to shut down. No action required.
What to check, and in what order, is in the app. The flow Coach Electrical — entry diagnostic (converters / inverters / solar / monitors) walks this code step by step with the pass/fail measurements, wiring schematics and procedures that go with it, and it works offline in the bay.
Start free trial 14 days free, no card neededDocumented in
- Conext XW Inverter/Charger Maintenance (Service) Guide 977-0017-01-01 Rev B (covers XW 6048 / XW 4548 / XW 4024)Schneider Electric
Related codes
- W58FET2 over-temperature (same condition as W57).
- W63AC overload: excessive load on the AC output.
- W64AC overload (same condition as W63).
- W68Transformer over-temperature (same condition/response as W57).
- W95Equalize aborted: equalization terminated abnormally because of…
- W96Cannot equalize: the selected battery type should not be equalized…
- W97Battery temperature sensor failure: the battery temperature sensor is…
- W500Lost network connection (Xanbus).
All Electrical (12V / 120V / Converter / Inverter) error codes · Look up another code