SlimRack Bed Lift error codes

9 codes from 3 manufacturers, each with its meaning and the document it comes from. Open a code for the details, or search every system.

SlimRack (7)

• 1G / 1RPark brake not set (MINOR). Applies to SlimRack 700156 control module variant only — control requires a…
• 1G / 2RLow voltage (MINOR). Supply below 12 V DC at the control box. The bed will not move if voltage falls to 10.5…
• 2G / 4RMotor fault (MAJOR). IMPORTANT: the specific motor referenced depends on the control box generation. On the…
• 1G / 6RHigh voltage (MINOR). Supply at 17 V DC or greater to the control box (older docs list the diagnostic test…
• 1G / 7RStops (MAJOR). Lowered or raised stop points have not been programmed, were cleared, or were improperly set.
• 1G / 8RMotor fuse (MAJOR). Internal motor-circuit fuse in the control box has opened.
• 1G / 9RBattery dropout (MAJOR). Battery voltage fell below 8.5 V DC at some point during bed extension or retraction.

SlimRack (current) (1)

• 2G / 2RMotor 2 fault (MAJOR) — current Lippert SlimRack control box only (not used on the older Power Gear…

SlimRack (Power Gear box 1510000199) (1)

• 1G / 4RRail / Motor 1 problem (MAJOR) — older Power Gear 1510000199 control box only. Bad harness connection, low…